The fourth attempt of a final prelaunch test started on Saturday, with fueling of the rocket expected to begin Monday morning.
The crucial test, known as the wet dress rehearsal, simulates every stage of launch without the rocket leaving the launchpad at Kennedy Space Center in Florida.
This process includes loading supercold propellant, going through a full countdown simulating launch, resetting the countdown clock and draining the rocket tanks.
The results of the wet dress rehearsal will determine when the uncrewed Artemis I will launch on a mission that goes beyond the moon and returns to Earth. This mission will kick off NASA’s Artemis program, which is expected to return humans to the moon and land the first woman and first person of color on the lunar surface by 2025.
Three previous attempts at the wet dress rehearsal in April were unsuccessful, concluding before the rocket could be fully loaded with propellant due to various leaks. These have since been corrected, NASA says.
The NASA team rolled the 322-foot-tall (98-meter-tall) Artemis I rocket stack, including the Space Launch System and Orion spacecraft, back to the launchpad at Kennedy Space Center in Florida on June 6.
Wet dress rehearsal steps
The wet dress rehearsal began at 5 p.m. ET Saturday with a “call to stations” — when all of the teams associated with the mission arrive at their consoles and report they’re ready for the test to begin and kick off a two-day countdown.
Preparations over the weekend will set up the Artemis team to start loading propellant into the rocket’s core and upper stages.
Tanking was on hold Monday morning because of an issue identified with the backup supply of gaseous nitrogen. The launch team replaced the valve causing the issue. In order to make sure the backup supply is functioning as expected, it has been swapped in as the primary supply for today’s test.
The hold lifted at 9:28 a.m. ET. Liquid oxygen, cooled to minus 297 degrees Fahrenheit (minus 182 degrees Celsius), and liquid hydrogen were used to fill the core stage before moving on to the rocket’s upper stage. Venting has been visible from the rocket throughout the process.
The core stage has been mostly filled and the team was filling the upper stage when several issues occurred just after 2 p.m. ET.
The team discovered a hydrogen leak at a quick disconnect line for the core stage and are troubleshooting it. Their first option did not work and they are looking to see if there is another way to to seal the leak.
Something from the flare stack, where excess liquid hydrogen from the rocket us burned off with propane flames, has caused a small grass fire burning toward a dirt road. The team is monitoring the grass fire and does not expect it to become an issue because it’s likely the fire will die out when it reaches the dirt road.
Currently, the rocket’s four tanks are filled.
The test has exceeded a planned 30-minute hold, which has been extended as engineers try to work on solutions for the hydrogen leak.
If the leak cannot be sealed today, the Artemis team may go through their planned countdowns and see how far they can go.
Counting down
There are two countdowns during the wet dress rehearsal. First, team members will go through a countdown to 33 seconds before launch, then stop the cycle. The clock will be reset; then the countdown will resume again and run until about 10 seconds before a launch would occur.
“During the test, the team may hold during the countdown as necessary to verify conditions before resuming the countdown, or extend beyond the test window, if needed and resources allow,” according to an update on NASA’s website.
The previous wet dress rehearsal attempts have already completed many objectives to prepare the rocket for launch, said Charlie Blackwell-Thompson, Artemis launch director for NASA’s Exploration Ground Systems Program, during a Wednesday news…
Read More: Ongoing Artemis moon rocket’s final prelaunch test faces issues on the launchpad